New cement render on bare brick or block across the whole of a 2-storey house in Barden Ridge 2234. Tradie to include scaffolding. Timing: within 2 weeks. Wall area approximately 200 sqm, to be confirmed on site.

Specific Job Details:

Schedule: Need job done in the next few weeks

Budget: Not Specified

Site Visit: Anytime

Hey everyone,I’m renovating my kitchen and looking for a renderer or plasterer to repair and smooth out the kitchen walls after the removal of the old splashback tiles

I’ve attached photos showing the current condition of the walls. Most of the walls are brick and concrete. Some areas have been damaged during tile removal and will need patching and rendering, while other areas are in reasonably good condition and will only need a light skim coat to make them smooth and even.

There is also one section, where a cement board was removed, exposing a timber frame behind it. This area will need a new cement sheet or suitable board installed, then rendered and finished to match the surrounding wall.

The overall goal is to have all the affected walls smooth, flat and even, ready for painting which I’ll be doing after. We will be installing new kitchen cabinets afterwards.

Ideally, I’d like the job completed on Thursday 5th or Friday 6th November however can be later if needed

Please include labour and materials in your quote, feel free to ask any questions

Thank you

Specific Job Details:

Schedule: Need job done in the next few of weeks

Budget: $200 - $500

Site Visit: Anytime

Hi

I need rendering (Rockote full system incline mesh) for retaining walls and some patching to house. Circa 250sqm.immediate start. Prefer sqm rate.

Specific Job Details:

Schedule: I’m flexible

Budget: Not Specified

Site Visit: Weekdays
Site Visit: Business-hours

Patching and levelling walls in 2 bathrooms following renovation ready for tiler to start. Must be able to work immediately as let down by others.

Specific Job Details:

Schedule: Need job done urgently

Budget: Over $1000

Site Visit: Anytime

We have a hob wall that needs to be rendered.

About 20meters long and 60cm tall

Specific Job Details:

Schedule: Need job done in the next few of weeks

Budget: Not Specified

Site Visit: Anytime

New cement render to the exterior walls of a 3-bedroom house. Per the customer's photo, the walls look like unrendered concrete block or brick in fair condition with patchy existing render in places, and may need cleaning and some repair before rendering. A second photo shows a single-storey home about 12-15m wide with weathered cream rendered walls, possible damp staining on the left side and climbing plants attached, so the existing render may need repair or removal. Wanted ASAP. Total wall area to be confirmed on site by the tradie.

Specific Job Details:

Schedule: Need job done urgently

Budget: Not Specified

Site Visit: Anytime

Hi house is already rendered old house
need cracks and corners of walls and windows re rendered due to rusted edges
Have cracks on walls around house
Approx 2 days work, old style render with pattern through it

Specific Job Details:

Schedule: I’m flexible

Budget: $2000 - $5000

Site Visit: Weekdays
Site Visit: Business-hours

Budget: $1,000 AUD

Looking for a highly experienced render repair specialist to rectify visible staining, joint marks and uneven finishes on a second-storey external rendered wall in Mount Waverley.

The property is a newly built luxury home preparing for open inspections, so a flawless, professional finish is essential.

Requirements:

* Repair all visible defects and match the existing render texture and colour seamlessly.
* No visible patch marks, stains or colour differences after completion.
* Must have suitable equipment for safe second-storey access (ladder, boom lift or EWP).
* All labour, materials and access equipment must be included in the $1,000 budget.
* Must have proven experience in high-quality render rectification.

Payment condition: Full payment will only be made after the work is completed, inspected and approved against the agreed finish requirements. No upfront payment.

Please only apply if you are confident you can achieve a high-quality, seamless finish. Photos available.

Specific Job Details:

Schedule: Need job done urgently

Budget: Over $1000

Site Visit: Anytime

[ This Customer has not provided a phone number. Only express interest if you're happy to correspond by message through the site. - Customer Support ]

Repair, render & or paint various areas of the strata building externally as attached photos

Specific Job Details:

Schedule: Need job done in the next few of weeks

Budget: Not Specified

Site Visit: Anytime

Patch render top of bathroom walls, 2 courses high for then tile fixing after. Tiling by others. Patch render walls where old picture railing was.

Specific Job Details:

Schedule: Not Specified

Budget: $500 - $1000

Site Visit: Anytime

Hi I have a small section of render that has cracked with wear and tear and the mesh behind it seems to have lost adherence to the foam underneath. I have the render and was going to attempt to do myself but have decided to get a professional for a professional finish. Will likely need mesh to be pulled off and start again in that section. I have highlighted in the photos what the likely section to be done is. I don’t have the funds to replace the entire wall so only looking to replace the section that had lost adherence to the wall as pictured.

Specific Job Details:

Schedule: Need job done in the next few weeks

Budget: Not Specified

Site Visit: Weekdays
Site Visit: Anytime

Hi,

I’m looking for a quote to microcement three areas in my home. The existing surfaces are painted tiles, and I’d like to understand the cost of applying microcement over them.

Could you please provide a separate quote for each area, as well as a combined quote for all three jobs?

1. Ensuite bathroom

Floor: 1.9 m × 3 m

Plus one wall: 1.9 m × 2.7 m

2. Main bathroom

Floor: 1.8m m × 3.3 m

3. Toilet area

Floor: 1.3 m × 1.8 m

I’ve attached photos of the existing areas for reference.

Specific Job Details:

Schedule: I’m flexible

Budget: Not Specified

Site Visit: Anytime

Hi, I’m just looking to have a small section of render patched where the floor tiles were removed, leaving a gap approximately 40mm wide on average and 12m long.

The existing render finish is Granosite in Dulux Natural White. I’m looking to have the patched area matched as closely as possible to the existing finish.

Could you please assist with and provide an estimate? Thanks.

Specific Job Details:

Schedule: Not Specified

Budget: Not Specified

Rendering to be done on a front and right side of the existing brick house, front need to be sponge finish, require site visit please.

Specific Job Details:

Schedule: Need job done in the next few of weeks

Budget: Not Specified

Site Visit: Anytime

External Rendering (~600 m²)

Location: South-Eastern Suburbs, Melbourne

Project: Two-Storey Residential Brick Block

Start: ASAP / By Negotiation

Scope of Work (Mandatory 3-Coat System + Scaffolding)
Scaffolding: Contractor to supply, erect, maintain, and dismantle all necessary perimeter scaffolding and edge protection for the two-storey structure (compliant with WorkSafe VIC standards).

Preparation: Mask all windows/doors/walkways, and install PVC corner beads and expansion joint mastic.

Coat 1 (Base Coat): Polymer-modified leveling render over primed brick substrate.

Coat 2 (Texture Coat): Flexible acrylic texture coat floated to a consistent, even sponge finish.

Coat 3 (Protective Membrane): High-build elastomeric protective barrier coat (Dulux AcraTex, Rockcote, or approved equivalent).

Handover: Full de-masking and daily site clean-up.

Requirements
Public Liability Insurance ($10M+) and WorkSafe cover.

Specific Job Details:

Schedule: Not Specified

1. BBQ area – Brickwork: Tidy up and repair the loose, uneven or damaged bricks around the BBQ area. Re-lay where necessary for a neat finish.

2. Courtyard – Concrete edging: Repair and straighten the concrete edging between the brick courtyard and the grey concrete floor.

3. Concrete floor – Cracks: Fill and repair existing cracks and damaged sections of the concrete floor, leaving a smooth finish ready for painting.

4. Internal floor – Step removal: Remove the sloped concrete transition shown in the last photo and rebuild it as a clean, straight vertical step (90° edge) rather than a gradual slope.

Replace steps with cement slope/ramp outside the entrance.

Need to be wheelchair friendly.

The cement color should match.
Meters by 1.3 meters

Specific Job Details:

Schedule: Need job done in the next few of weeks

Budget: Not Specified

Site Visit: Anytime

VAPOR BARRIER

Strip back and Re-render of an existing external brick wall, approx. 24.7 sqm

Looking for a renderer to re-render an outside brick wall that has old render on it. The old render is to be stripped back and re-done. Total: about 35.5 lineal metres of wall, 400mm to 1m high, approx. 24.7 sqm to render. The wall is stepped at different heights they are detailed below: Wall dimensions (length x height): 8.2m long x 1000mm high (8.2 sqm) 6.7m long x 700mm high (4.7 sqm) 6.7m long x 600mm high (4.0 sqm) 5.7m long x 600mm high (3.4 sqm) 8.0m long, stepped through three heights of 400mm, 550mm and 700mm (4.4 sqm) Total: about 35.5 lineal metres of wall, 400mm to 1m high, approx. 24.7 sqm to render.
Please quote for labour and materials to re-render the full area.

Specific Job Details:

Schedule: I’m flexible

Budget: Not Specified

I need 2 bathrooms rendered, 2 walls each bathroom 1 wall 1: 3x2.9 wall 2: 1.9x2.9
Bathroom 2 wall 1: 1.6x2.9 wall 2: 2.8x2.9

I also need to fix a patch up a window to meet with the edge and rendered for tiling please see photos

Specific Job Details:

Schedule: Need job done urgently

Budget: Not Specified

Site Visit: Weekdays

Repair cracking external wall cladding sheet joint and texture finish

Looking for an experienced renderer or specialist tradeperson to repair a vertical cracks along an external wall cladding sheet joints at multiple places (attaching a few photos). The job requires cleaning out/v-grooving the joint, properly sealing and reinforcing the area to prevent future movement, and patching/re-texturing the surface to match the surrounding wall coating seamlessly.
Also have to put in some screws and re-attach the foam. Attached highlighted pictures.

No requirement to re-texture the whole wall and closest possible match to the wall color is acceptable.

Therefore no requirement for scaffolding and can be accomplished with a double storey ladder.

Attaching more pictures of the screws and the foam.

Specific Job Details:

Schedule: I’m flexible

Budget: Not Specified

I need the following areas within a toilet rendered -
- Around the door frame
- Small window frame (edges only)
- 2 patches on the wall as per the photos

Specific Job Details:

Schedule: I’m flexible

Budget: Not Specified

Site Visit: Anytime

Microcement Installer Wanted - Ground Floor

Looking for an experienced microcement installer to inspect and quote onsite.
- Planning to use Ecoflor microcement (https://ecoflor.com.au/)

I will have a carpenter come and do some levelling out of the flooring prior to the job start as well

Available for inspections from 10 October.

Areas:
- Lounge/dining - timber floor will be raised and levelled beforehand by carpenteer
- Kitchen
- Front verandah
- Hallway/walkway
- Courtyard walkway only - not brick paving

redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work redering work

Specific Job Details:

Schedule: Not Specified

Budget: Not Specified

Site Visit: Anytime

render for paint finish, 2.2m high 4.8m long wall, also a little touch up around a window that we installed. just render, all plastic trims are on. Looking for quality only, ready to go. thanks

Specific Job Details:

Schedule: I’m flexible

Budget: Not Specified

Site Visit: Anytime